How to Remove Your Volkswagen Jetta Radio in 60 Seconds
How to Remove the Radio from a 2011 Volkswagen Jetta
This guide will show you how to remove the radio from a 2011 Volkswagen Jetta. The radio is a relatively simple unit to remove, and can be done with a few basic tools. By following these steps, you can remove the radio from your Jetta in just a few minutes.
So, How To Remove Radio From 2011 Volkswagen Jetta?
1. Remove the trim panel below the radio.
2. Disconnect the electrical connectors to the radio.
3. Remove the two screws that secure the radio to the dashboard.
4. Pull the radio out of the dashboard.
How to Remove Radio from a 2011 Volkswagen Jetta
Tools Needed
Phillips head screwdriver
Torx T20 screwdriver
Tape measure
Pliers
Plastic pry tool
Step 1: Remove the trim panel
1. Use the Phillips head screwdriver to remove the two screws that secure the trim panel to the dashboard.
2. Pry up the trim panel with the plastic pry tool.
3. Remove the trim panel.
Step 2: Disconnect the wiring harness
1. Locate the wiring harness that connects to the radio.
2. Use the Torx T20 screwdriver to remove the two screws that secure the wiring harness to the radio.
3. Disconnect the wiring harness from the radio.
Note:
Be careful not to damage the wiring harness when disconnecting it from the radio.
Step 3: Remove the radio
1. Grasp the top of the radio and pull it out of the dashboard.
2. The radio should come out easily.
Step 4: Install the new radio
1. Reverse the steps above to install the new radio.
2. Make sure that the wiring harness is connected to the radio correctly.
3. Secure the trim panel to the dashboard with the Phillips head screws.
Congratulations! You have successfully removed and replaced the radio in your 2011 Volkswagen Jetta.
MUST READ THIS: How To Remove 2007 Volkswagen Jetta Alternator
FAQs: How to Remove Radio from a 2011 Volkswagen Jetta
What tools do I need to remove the radio from my 2011 Volkswagen Jetta?
A Phillips head screwdriver
A Torx T20 screwdriver
A pry bar
How do I remove the trim around the radio?
1. Use the Phillips head screwdriver to remove the two screws that hold the trim in place.
2. Use the Torx T20 screwdriver to remove the two screws that hold the radio in place.
3. Use the pry bar to pry the trim away from the radio.
How do I disconnect the wiring harness from the radio?
1. Locate the wiring harness connector on the back of the radio.
2. Press down on the locking tab and pull the connector away from the radio.
How do I remove the radio from the dashboard?
1. Pull the radio out of the dashboard until it is free from the mounting clips.
2. Disconnect the antenna cable from the back of the radio.
How do I install a new radio in my 2011 Volkswagen Jetta?
1. Reverse the steps above to install the new radio.
2. Make sure to connect the antenna cable to the back of the radio.
