how to remove 2011 volkswagen jetta
How to Remove a 2011 Volkswagen Jetta
The 2011 Volkswagen Jetta is a popular compact car that is known for its reliability and fuel efficiency. If you need to remove the Jetta’s front bumper, there are a few steps involved. In this guide, we will walk you through the process in an easy-to-follow manner.
What You Will Need
A flathead screwdriver
A Phillips head screwdriver
A 10mm socket wrench
A 12mm socket wrench
A ratchet
A set of metric wrenches
Safety glasses
Work gloves
So, How To Remove 2011 Volkswagen Jetta?
1. Remove the negative battery cable.
2. Disconnect the electrical connector from the fuel pump.
3. Remove the two bolts that secure the fuel pump to the fuel tank.
4. Carefully lift the fuel pump out of the fuel tank.
5. Reconnect the electrical connector to the fuel pump.
6. Connect the negative battery cable.
How to Remove a 2011 Volkswagen Jetta
Tools and Materials
Wrench
Socket set
Screwdriver
Penetrating oil
Rags
Safety glasses
Step 1: Raise the Vehicle
1. Park the vehicle on a level surface.
2. Engage the parking brake.
3. Turn off the engine and remove the key from the ignition.
4. Open the hood and locate the front jack points.
5. Place the jack under the front jack point on the driver’s side.
6. Raise the vehicle until the front wheels are off the ground.
7. Place the jack stands under the rear jack points.
8. Lower the vehicle onto the jack stands.
Step 2: Remove the Wheels
1. Remove the lug nuts from the front wheels.
2. Use the lug wrench to loosen the lug nuts a few turns at a time.
3. Continue to loosen the lug nuts until they are loose enough to remove by hand.
4. Remove the lug nuts and set them aside.
5. Pull the wheels off of the vehicle.
Step 3: Remove the Brake Calipers
1. Locate the brake calipers on the front of the vehicle.
2. Remove the caliper bolts.
3. Use a screwdriver to pry the caliper away from the rotor.
4. Remove the caliper from the vehicle.
Step 4: Remove the Brake Rotors
1. Remove the caliper bolts.
2. Use a screwdriver to pry the rotor away from the hub.
3. Remove the rotor from the vehicle.
Step 5: Remove the Hub Assembly
1. Remove the axle nut.
2. Use a pry bar to pry the hub assembly away from the axle.
3. Remove the hub assembly from the vehicle.
Step 6: Remove the Transmission
1. Disconnect the battery.
2. Remove the transmission fluid drain plug.
3. Drain the transmission fluid into a drain pan.
4. Remove the transmission fluid pan.
5. Remove the transmission mount bolts.
6. Remove the transmission crossmember bolts.
7. Disconnect the transmission wiring harness.
8. Disconnect the transmission shift linkage.
9. Remove the transmission from the vehicle.
Step 7: Install the New Transmission
1. Install the transmission on the vehicle.
2. Connect the transmission wiring harness.
3. Connect the transmission shift linkage.
4. Install the transmission crossmember bolts.
5. Install the transmission mount bolts.
6. Install the transmission fluid pan.
7. Fill the transmission with the correct amount of fluid.
8. Reconnect the battery.
Step 8: Reinstall the Wheels
1. Place the wheels on the vehicle.
2. Install the lug nuts.
3. Tighten the lug nuts a few turns at a time.
4. Continue to tighten the lug nuts until they are snug.
5. Lower the vehicle to the ground.
Step 9: Test Drive the Vehicle
1. Take the vehicle for a test drive.
2. Check for any leaks.
3. Make sure the transmission is shifting properly.
4. Enjoy your new transmission!
MUST READ THIS: 2013 Volkswagen Jetta How To Remove Door Panel
FAQs: How to Remove a 2011 Volkswagen Jetta
What tools do I need to remove a 2011 Volkswagen Jetta?
A 10mm socket
A 12mm socket
A 17mm socket
A torque wrench
A breaker bar
A set of screwdrivers
Penetrating oil
A rag
How do I remove the front bumper on a 2011 Volkswagen Jetta?
1. Open the hood and disconnect the negative battery cable.
2. Remove the two 10mm bolts that secure the front bumper to the fender liner.
3. Remove the two 10mm bolts that secure the front bumper to the radiator support.
4. Remove the two 12mm bolts that secure the front bumper to the chassis.
5. Pull the front bumper away from the car and disconnect the wiring harness.
6. Remove the front bumper.
How do I remove the rear bumper on a 2011 Volkswagen Jetta?
1. Open the trunk and disconnect the negative battery cable.
2. Remove the two 10mm bolts that secure the rear bumper to the fender liner.
3. Remove the two 10mm bolts that secure the rear bumper to the trunk lid.
4. Remove the two 12mm bolts that secure the rear bumper to the chassis.
5. Pull the rear bumper away from the car and disconnect the wiring harness.
6. Remove the rear bumper.
How do I remove the door on a 2011 Volkswagen Jetta?
1. Open the door and disconnect the negative battery cable.
2. Remove the two 10mm bolts that secure the door to the hinge.
3. Remove the two 12mm bolts that secure the door to the body.
4. Pull the door away from the car and disconnect the wiring harness.
5. Remove the door.
How do I remove the hood on a 2011 Volkswagen Jetta?
1. Open the hood and disconnect the negative battery cable.
2. Remove the two 10mm bolts that secure the hood to the hinge.
3. Remove the two 12mm bolts that secure the hood to the windshield.
4. Pull the hood away from the car and disconnect the wiring harness.
5. Remove the hood.
